Ducati SUPERBIKE 1098 Tricolore Use And Maintenance Manual page 24

Lap time display
To activate this function, go into the menu and set the "LAP"
function to "On" by keeping button (1, fig. 8) in position B
"▼" for 3 seconds.
START and STOP the timer by pressing the high beam
FLASH button (12, fig. 5) on the left-hand handlebar switch.
When the LAP function is active, each time you press the
FLASH button, the display will show the lap time for
E
10 seconds, before reverting to normal mode.
You can save a maximum of 30 laps in the memory.
If the memory is full, each time you press the FLASH button,
the display will not save any more lap times and will display
the flashing message "FULL" for 3 seconds until the
memory is reset.
fig. 18
24