Shifting Procedures - Jeep 2011 Grand Cherokee Owner's Manual

Hide thumbs Also See for 2011 Grand Cherokee:

Table of Contents

and rear wheels to rotate at the same speed. It provides

additional traction and maximum pulling power for

loose, slippery road surfaces only. Do not exceed 25 mph

Refer to "Selec-Terrain

further information on the various positions and their

intended usages.

Shifting Procedures

4WD HI to 4WD LOW

With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h), the

ignition switch in the ON position or the engine running,

shift the transmission into NEUTRAL, and press the

"4WD LOW" button once on the transfer case switch. The

"4WD LOW" indicator light in the instrument cluster

will begin to flash and remain on solid when the shift is

– If Equipped" for

NOTE: If shift conditions/interlocks are not met, or a

transfer case motor temperature protection condition ex-

ists, a "For 4x4 Low Slow Below 3 MPH or 5 KPH Put

Trans in N Press 4 Low" message will flash from the

Electronic Vehicle Information Center (EVIC). Refer to

"Electronic Vehicle Information Center (EVIC)" in "Under-

standing Your Instrument Panel" for further information.

STARTING AND OPERATING 357

Transfer Case Switch

Table of Contents