Lennox Hearth Products Elite Series Installation And Operation Manual page 10

4) Rotate the right front log (3018 is cast into its bottom surface) so the
black charred surface is toward the front. Place this log so the two
holes in its bottom surface slide onto the two pegs on the right side
of the air control panel. See Figure 11.
5) Rotate the left front log (3017 is cast into its bottom surface) so the
black charred surface is toward the front and place it on the pegs
protruding from the left side of the air control panel as shown in
Figure 11.
6) The small straight top twig (3021) should be turned so the black flat
end is turned to the rear. Slide the holes in the bottom of this twig
over the right peg on the left front log and the hole on the right front
log. See Figure 12.
7) The left top log (3019) should be positioned as shown in Figure 12.
Slide the holes in the bottom of this log over the hole in the left end of
the rear log and the peg in the left end of the left front log. The right
top log (3020) should be positioned as shown in Figure 12. Slide the
holes in the bottom of this log over the peg in the right end of the right
front log and rest it on the flat spot on the rear log.
8) Figure 13 shows the entire log set assembled. The embers provided
may be placed one high in front of the front burner tube using care not
to cover all the burner ports. Any extra embers may be placed at the
ends of the front log, off the burner. Place small pinches of rockwool
on top of the embers.
Figure 11
10
Left Top
Log
Hole to
Cover
Figure 12
Note: The pilot
flame can be
viewed through
this hole in the
front log.
Embers
Figure 13
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Right Top Log
Hole to
Cover
Flat Area