Lennox Hearth Products DES-BS Installation Instructions

INSTALLATION INSTRUCTIONS FOR BARRIER SCREEN KIT
FOR USE WITH MODEL DESIGNER™ Bv GAS FIREPLACE INSERT
KIT CONTENTS
1 ea. Barrier Screen
1 ea. Instruction Sheet
Cat. No. Model
H7725 DES-BS
Figure 1 - Barrier Screen Kit
TOOLS REQUIRED
5/32" Allen Wrench
GENERAL INFORMATION
If you encounter any problems, need clarification of these instructions or
are not qualified to properly install this kit, contact your local distributor
or dealer.
Read this instruction sheet in its entirety before beginning the installa-
tion.
All of these parts may scratch and bend, great care should be used
in handling them.
Description
Barrier Screen Kit, Designer
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
P/N 506033-26
Rev. NC, 06/2009
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROvIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
TURN OFF THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
INSTALLATION INSTRUCTIONS
Step 1. Remove the barrier screen from the packaging.
Step 2. If an accessory face is installed on the unit, it must be removed
from the unit before proceeding with the barrier screen installa-
tion. For detailed instructions on removing a specific accessory
face, please refer to the instruction sheet that was supplied with
the face.
Step 3. You must first remove the glass door to install the barrier screen.
To remove the glass door, use an allen wrench to remove the
upper two screws and loosen the lower three screws (see Figures
2 and 3). Lift the glass door up and off the lower three screws.
Be careful not to damage or scratch the glass while handling. Do
not operate the insert with the glass removed.
Upper Two Door Mounting Screws
Lower Three Door Mounting Screws
Figure 3 - Door Mounting Screws
HEARTH PRODUCTS
KITS AND ACCESSORIES
BARRIER SCREEN KIT
MODEL DESIGNER™