Garmin GPS 400W,GNC 420W Pilot's Manual & Reference page 166

9 - AUX PAGES
Flight Planning
transfer cancelled" are received during an automatic or
manual transfer, the pilot must force another transfer.
To transfer flight plans or user waypoints to/from
a second 400W (or 500W) Series unit:
1. Select "Crossfill" from the flight planning
page.
2. The flashing cursor highlights the method field.
Turn the small right knob to select "Auto" or
"Manual". "Auto" will automatically transfer
any selection of (or any change to) a direct-to
destination or active flight plan to a second
400W or 500W Series Garmin unit.
NOTE: Crossfill requires both 400W and/or 500W
series units to have the same Jeppesen NavData
database cycle number.
3. The flashing cursor highlights the transfer data
option (TRANSFER) field.Turn the small right
knob to display a window of available data
options:
• Active Flight Plan—transfer the active flight
plan to/from a second 400W/500W-series
Garmin unit in a dual unit installation. This
option is the default when selecting "Crossfill"
from the flight planning page.
• Flight Plan—transfer any stored flight plan
to/from a second 400W/500W-series unit,
by selecting the flight plan by number. This
option is the default when selecting "Crossfill"
from the flight plan catalog.
• User Waypoints (all)—transfer all
stored user waypoints to/from a second
400W/500W-series unit.
• User Waypoint—transfer the specified user
waypoint to a second 400W/500W-series
unit.
156
Continue turning the small right knob to
4.
select the desired data option. Press ENT when
®
finished.
5. For a stored flight plan ("Flight Plan" data
option), the flight plan number field is high-
lighted. Turn the small right knob to select
the desired flight plan and press ENT.
6. For a specified user waypoint ("User Waypoint"
data option), the waypoint identifier field is
highlighted. Use the small and large right
knobs to enter the identifier of the desired user
waypoint. Press ENT when finished.
7. The flashing cursor moves to the "CROSS-SIDE"
field.Turn the small right knob to select "To"
or "From" and press ENT.
8. The flashing cursor moves to the "Initiate
Transfer?" confirmation field. Press ENT to
transfer the selected data.