My Book World Edition Basic Setup
2
Step 1: Connect My Book World Edition to the Network
Follow the steps below to connect the network storage system to a small
home/office network.
1. Connect one end of the Ethernet cable into the Ethernet port located on the back
of the device.
2. Connect the other end of the Ethernet cable directly into a LAN port in a router or
network switch.
3. Connect the end of the adapter into the DC power supply socket located on the
back of the device.
4. Plug the AC adapter into a power outlet. The unit powers up automatically.
Important:
three minutes) before configuring the device. During this time, do not press the power
button. The bottom LED on the front of the My Book device fully illuminates.
To power down the device, press and hold down the power button down for at
least four seconds.
4
Wait for the network storage system to finish powering up (approximately
1
3
MY BOOK WORLD EDITION BASIC SETUP - 10
MY BOOK WORLD EDITION
USER MANUAL
2