Table of Contents
Advertisement
The Copy Tape Button makes
Sync Editing a snap
4
Play the source tape in Deck 1 to the beginning of the
first scene (in our example this is tape counter position
0:01:08). Press the
the scene.
5
Play the tape to the end of the scene (in our example this
is tape counter position 0:03:34). Press the
mark the end of the scene.
Note: After you program each scene, the next scene
number will blink indicating it's ready to be
programmed.
6
Press the number for the next scene you want to
program (in our example, scene 2).
7
Repeat steps 4-6 until all scenes are programmed.
8
Press
to stop the tape in Deck 1.
STOP
Note: You cannot eject the tape in Deck 1 with the
remote control if there are scenes in the Edit List.
9
Load a blank tape into Deck 2.
10
Press the
COPY TAPE
cally copy each scene from Deck 1 to Deck 2 in the order
programmed.
11
When editing is complete, stop Deck 2.
Sync Editing
You can also perform assembly editing manually, also known
as Sync (Synchronized) Editing.
Note: For best results when Sync editing, be sure to:
• Turn on the On-Screen Display (p.12)
• Turn off EZ-Copy (p.19)
• Turn off Auto Play (p.23)
1
Insert the source tape into Deck 1.
2
Insert the target tape into Deck 2.
3
Press
to select Deck 2.
DECK 2
4
Play the target tape in Deck 2 to approximately 3
seconds after the end of the last frame of the last scene,
then press
PAUSE/STILL
5
Press
for Deck 2. This puts the deck into Record
RECORD
Pause mode.
6
Press
to select Deck 1.
DECK 1
7
Play the source tape in Deck 1 to the beginning of the
desired scene and press
will blink.
8
Push
to begin editing.
COPY TAPE
9
The source tape will copy onto the target tape until you
press
on Deck 2, or
STOP
Sync Edits.
key to mark the beginning of
BEGIN
key. The Dual-Deck VCR will automati-
.
. The Copy Tape button
PAUSE/STILL
again to make additional
COPY TAPE
CHAPTER 7 - EDITING FEATURES
key to
END
35
Advertisement
Table of Contents
