Table of Contents
Advertisement
Searching &
Index Features
Tape Counter
Time Remaining
Press
to cycle the front
CLK/CTR
panel display among the clock,
tape counter and time remaining.
The Tape Counter (circled left) and
Time Remaining (circled right)
appear on-screen for both decks.
The letter "M" signifies that
Memory Stop is enabled.
Tape Counter/Time Remaining
Clock
The Tape Counter shows you the exact location of your tapes in
hours, minutes and seconds. The Time Remaing indicator
shows you how much time is left until the end of the tape.
You can view the tape counter/time remaining in two places:
Front Panel Display - Press
front panel display among the clock, tape counter and
time remaining.
On-Screen Display - Press
time remaining on-screen for both decks (the OSD will
match the Front Panel Display).
To reset the tape counter:
1
Press
until the tape counter is displayed on the
CLK/CTR
front panel display.
2
Press
to reset the counter to 0:00:00. You can do
CLEAR
this anywhere on a tape.
Note: Any time you insert a tape into your Dual-Deck VCR,
the Tape Counter will reset to zero automatically.
Memory Stop
Memory Stop will automatically stop the tape at counter
position 0:00:00 when rewinding or fast-forwarding. This is
a handy feature when editing videotapes.
To activate Memory Stop:
1
Press
on the remote control. You will see an "M"
MEMORY
below the tape counter setting on the On-Screen Display.
2
Press
or
REW
tape counter position 0:00:00 and stop automatically.
C H A P T E R
repeatedly to switch the
CLK/CTR
to view the counter or
DISPLAY
. Your Dual-Deck VCR will advance to
FF
CHAPTER 8 - SEARCHING & INDEX FEATURES
8
37
Advertisement
Table of Contents
