ProForm 764hr Bike User Manual page 6

5. Attach the Seat (12) to the Seat Frame (6) with three
M6 x 16mm Screws (64).
6. Attach the Backrest (10) to the Backrest Frame (5)
with two M6 x 16mm Screws (64), an M6 x 50mm
Screw (69), and an M6 Flat Washer (71).
7. Whilst another person holds the Upright (13) in the
position shown, connect the Upper Wire Harness (35)
to the Lower Wire Harness (36). Carefully pull the
upper end of the Upper Wire Harness to remove
any slack from the Wire Harnesses.
Turn the Knob (not shown) on the right side of the
Frame (1) counterclockwise until it is loose. Next, pull
the Knob, insert the Upright (13) into the Frame, and
then release the Knob. Move the Upright up and
down slightly until it locks into position. Be careful
to avoid pinching the Wire Harnesses (35, 36).
Tighten the indicated M6 x 25.4mm Button Screw (79)
into the slot in Upright.
8. Whilst another person holds the Console (16) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (35). Insert the
excess wire harness into the Upright (13).
Attach the Console (16) to the Upright (13) with four
M4 x 16mm Screws (73). Be careful to avoid pinch-
ing the wire harnesses.
Attach the Water Bottle Holder (89) to the Upright (13)
with two M4 x 22mm Screws (91).
5
12
6
6
10
7
1
79
8
73
13
6
64
64
5
71
64
13
Slot
35
36
Knob
Wire
Harness
35
89
91
69
16