Table of Contents
Advertisement
Available languages
Available languages
Installation proud of the work surface
• Use the installation template supplied to mark out the cut-out in the
work surface.
• Clean the worktop around the cut-out area.
• Stick the single-sided adhesive sealing tape provided on the under-
side of the hob around the outside edge ensuring that it is not
stretched. The two ends of the tape should join in the middle of one
side. After trimming the tape (allow it to overlap by 2-3 mm), press
the two ends together.
1
Remarks:
If the corner joint of the worktop is connected with clamping elements,
then care must be taken that at least the front clamps left and right are
removed, after curing the adhesive and before installation of the hob.
49
Advertisement
Chapters
Table of Contents
