Verify Speed Sensor (Tc1000 Only) - Bowflex TREADCLIMBER 1000 Owner's Manual

Verify Speed Sensor (TC1000 only)

IMPORTANT!! NAUTILUS STRONGLY RECOMMENDS
THAT YOU TEST THE SPEED SENSOR BY
PERFORMING THE FOLLOWING TEST BEFORE FIRST
USE.
Procedure to verify proper Speed Sensor Connection and
Operation
With your TreadClimber
1-1
grounded wall outlet and safety key inserted, turn
power on using the red switch at rear of machine.
1-2 Standing to the left of the machine activate the Start
Stop switch. Belts should begin moving within a few
seconds.
1-3 Allow belts to continue to turn for at least 15 seconds
(elapsed time will be displayed on Console). If belts
stop, or speed increases, note any error codes
displayed on Console and turn power off at rear of
machine. Contact customer service for assistance.
1-4 Push FASTER button until SPEED display reads 1.5.
Verify belt speed increases and then holds constant at
new speed.
Remove safety key. Belts should slow to a complete
1-5
stop.
1-6 Replace safety key. Belts should remain stopped.
Push reset button on Console. Your TC 1000 is now
1-7
ready to use. Review this manual for operating
instructions.
Note: If your TreadClimber
described in the above steps do not use machine.
Contact Customer Service for assistance immediately
at 1-800-605-3369 .
28
Owner's Manual
Repairs and Maintenance
machine plugged into a
®
machine does not operate as
®
Main Power Switch "On"