Lubrication System; Check Oil Level - Kohler Courage SV710 Service Manual

This engine uses a combination pressure/splash lubrication system, delivering oil under pressure to crankshaft,
connecting rod and main bearing surfaces. Other component areas are splash lubricated.
A high-efficiency gerotor oil pump maintains high oil flow and oil pressure, even at low speeds and high operating
temperatures. A pressure relief valve limits maximum pressure of system. Oil pan must be removed to service oil
pickup and oil pump.
Lubrication Components
A
A Oil Fill/Dipstick
OIL RECOMMENDATIONS
Refer to Maintenance.

CHECK OIL LEVEL

NOTE: To prevent extensive engine wear or damage,
never run engine with oil level below or above
operating range indicator on dipstick.
Ensure engine is cool. Clean oil fill/dipstick areas of any
debris.
1. Remove dipstick; wipe oil off.
a. Push-in cap: reinsert dipstick into tube; press
completely down.
b. Threaded cap: reinsert dipstick into tube and
thread on completely.
2. Remove dipstick; check oil level. Level should be at
top of indicator on dipstick.
3. If oil is low on indicator, add oil up to top of indicator
mark.
4. Reinstall and secure dipstick.
32 690 01 Rev. D
B
B
or
KohlerEngines.com
Oil Drain Plug
CHANGE OIL AND FILTER
Change oil while engine is warm.
1. Clean area around oil fill cap/dipstick. Remove drain
plug and oil fill cap/dipstick. Allow oil to drain
completely.
2. Clean area around oil filter. Place a container under
filter to catch any oil and remove filter. Wipe off
mounting surface. Reinstall drain plug. Torque to
13.6 N·m (10 ft. lb.).
3. Place new filter in shallow pan with open end up. Fill
with new oil until oil reaches bottom of threads. Allow
2 minutes for oil to be absorbed by filter material.
4. Apply a thin film of clean oil to rubber gasket on new
filter.
5. Refer to instructions on oil filter for proper
installation.
6. Fill crankcase with new oil. Level should be at top of
indicator on dipstick.
7. Reinstall oil fill cap/dipstick and tighten securely.
8. Start engine; check for oil leaks. Stop engine; correct
leaks. Recheck oil level.
9. Dispose of used oil and filter in accordance with
local ordinances.

Lubrication System

C
C Oil Filter
29