Hints And Tips - AEG LAVATHERM 76484EIH User Manual

HINTS AND TIPS

ECOLOGICAL HINTS
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g. with
a coffee filter) to remove possible small
pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes which are speci-
fied in the programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the primary filter after each dry-
ing cycle.
• Clean the heat exchanger filters when
the applicable indicator comes into the
view on the control panel.
• Spin good the laundry before drying.
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for differ-
ent locations. Water hardness has an ef-
fect on the water conductivity and the op-
eration of the conductivity sensor in the
appliance. If you know the value of the
water conductivity you can adjust the sen-
sor to dry with the better results.
To change the sensor conductivity:
1. Turn the programme dial to available
programme.
2. Push at the same time the Dry Plus
and the Anticrease buttons. Hold
down until one of the symbols go into
view on the display:
–
cm
–
300-600 μS/cm
–
cm
3. Push the Start Pause button again
and again until you set necessary lev-
el.
low conductivity <300 μS/
moderate conductivity
high conductivity >600 μS/
4. To memorise the setting push at the
same time the Dry Plus and the Anti-
crease buttons.
WATER CONTAINER FULL —
INDICATION
By default the indication LED is always on.
It comes into the view at the end of the
cycle or when the water container is full.
When you use an external equipment to
drain the container, the LED can be off.
To activate or deactivate the indication:
1. Turn the programme dial to available
programme.
2. Push at the same time the Dry Plus
and Buzzer buttons and hold down
until you see the correct setting:
– the LED is off and the symbol
goes into the view - The
LED is permanently off
– the LED is on and the symbol
goes into the view - The
LED is activated
ENGLISH
15