Installation - AEG LAVATHERM 76484EIH User Manual

INSTALLATION

APPLIANCE POSITIONING
• The tumble dryer must be installed in a
clean position, where dirt does not col-
lect.
• Air must flow freely around the appli-
ance. Make sure that the front airflow
slots in the bottom of the appliance are
not blocked .
• To keep vibration and noise at the mini-
mum, when the tumble dryer operates,
it must be put on a stable and flat sur-
face.
• When the appliance is put in its perma-
nent position, check if is fully level with
the aid of a spirit level. If it is not, adjust
the feet until it is.
• Do not remove the feet. Do not de-
crease the floor clearance through thick
carpets, bar of wood or equivalent. This
can increase the heat which can cause
interference with the operation of the
appliance.
• The temperature of the hot air
• When the tumble dryer oper-
• If it is necessary to move the ap-
• The appliance must not be in-
It is possible to adjust the height of the
tumble dryer. To do that adjust the feet
(see picture).
which occurs in the tumble dry-
er can increase to 60 °C. The
appliance must not be installed
on the floor which is not resist-
ant to high temperatures.
ates, the room temperature
must not be lower than +5 °C
and higher than +35 °C. This
can cause unwanted effect on
the performance of the appli-
ance.
pliance, it must be moved verti-
cally.
stalled behind a lockable door,
a sliding door, a door with a
hinge on the opposite side to
that of the appliance in such a
way that a full opening of the
tumble dryer is restricted.
15mm
UNPACKING
CAUTION!
Before use all parts of the transport pack-
aging must be removed.
To remove the polystyrene blockages:
1. Open the load door.
2. Pull plastic hose with the polystyrene
blockages out from the drum.
INSTALLATION UNDER A
COUNTER
The appliance can be installed as free-
standing or below the kitchen counter
with correct space (see picture).
ENGLISH
25