Table of Contents
Advertisement
Touching the Start/Pause button, the
ProSense starts the laundry load
detection:
1. The appliance detects the load in the
first minute: the indicator flashes, the
bars under the icon move back and
forth
shortly.
2. When the drum stops rotating, the
display shows the new program
duration adjusted according to the
detected load. The number of bars,
from 1 to 4, represents the estimated
load amount. 4 bars represent the
maximum load amount for the
selected program.
In case of drum overload,
the maximum declared load
indicator comes on again
with the
blinking. In this case, during
these 30 seconds, it is
possible to open the door
and remove the exceeding
garments. Once removed,
touch the Start/Pause button
to start the program again. If
the laundry amount will not
be reduced, the program
starts anyway. In this case, it
will be not possible to
guarantee the best results.
10.11 Program change
To change a program:
1. Push the On/Off button to turn the
appliance off.
11. HINTS AND TIPS
11.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which
are specified in the programs chapter.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• The water from the water container
can be used to iron the clothes. You
and the drum rotates
indicator
2. Push the On/Off button again to turn
on the appliance.
3. Set a new program.
10.12 Program end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the End
Signal option is activated, the acoustic
signal sounds intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programs). Flashing
symbol signals the execution
of the anti-crease phase.
Laundry can be removed
during this phase.
To remove the laundry:
1. Push the On/Off button for 2 seconds
to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level
settings. See chapter
default dryness level
• Room temperature is too low or too
high. Optimal room temperature is
between 18°-25°C.
must first filter the water to eliminate
remaining textile fibres (simple coffee
filter is suitable).
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
ENGLISH
23
Adjustment of
Advertisement
Table of Contents
