Cancel Print Job; Advanced Settings - SATO CL608e Operation Manual

Operation Manual
position and 9 mm for second position after which it will automat-
ically wrap and start of "00" again. The pitch direction set in the
previous step will be displayed in front of the Offset setting.
4. Once the setting is correct, press the FEED key to accept the
setting and advance to the Cancel Print job display.
5. You may wish to check your settings by printing a test label after
you have completed the adjustments to ensure that they are cor-
rect.

3.3.6 Cancel print Job

If the printer has a print job(s) loaded in memory, selecting YES will
cause the job(s) to be cleared. The default selection is NO. Make
sure that you want to cancel the print job before selecting YES as
the job cannot be recovered and will have to be retransmitted to the
printer.
To cancel the print perform the following steps:
1. Use the LINE key to step the blinking cursor to either YES or NO.
2. Once the correct setting is selected, press the FEED key to
accept the setting and terminate the user mode of operation and
return you to the normal mode ONLINE display.
If you wish to change any of the settings, you must first set the
printer to OFFLINE and enter the user mode again by simulta-
neously pressing FEED and LINE keys for more than one sec-
ond.

3.3.7 Advanced Settings

See Appendix A for advanced settings.
Please not that you will need special instructions for some of these
settings!
CL608e/612e
3. Configuration
CANCEL PRINT JOB
NO YES
29