Quick Reference Guide - Directed Electronics AM6 Owner's Manual

QUICK REFERENCE GUIDE:

To lock using your remote
To arm the system press
nected). The LED will begin to flash. The Failsafe
vent the vehicle's starter from cranking if it has been installed. The ve-
hicle's horn (if connected) will honk and the parking lights will flash
once to confirm arming of the system.
To unlock using your remote
To disarm the system press
be deactivated and the vehicle's horn (if connected) will honk twice and
the parking lights will flash twice.
Disabling the Failsafe
Turn on the ignition. Press and release the Valet
onds. The LED will stop flashing and the vehicle should start. Be sure to
check with the installer for the location of the Valet
To remote start the vehicle
Press twice within 3 seconds. The parking lights will turn on (if con-
nected) and the vehicle will start and run for the programmed amount
of time.
To enter or exit Valet
Turn the ignition to the "ON" position. Turn the ignition back off. Press
and release the Valet
light steadily if you have entered Valet
repeat the steps above. The LED will turn off when exiting Valet
To activate Panic Mode
Press and hold
To disable the remote start system
To disable the remote start, move the shutdown toggle switch to the OFF
position.
Location of Shutdown Switch______________________________
2003 Directed Electronics, Inc.
©
for one second. The doors will lock (if con-
for one second. The doors will unlock (if
connected). The Failsafe
®
Starter Kill without a transmitter
®
Mode
®
switch within 10 seconds. The status LED will
®
Mode. To exit Valet
for 1.5 seconds.
®
Starter Kill will pre-
®
Starter Kill will
®
switch within 10 sec-
®
switch.
®
Mode,
®
Mode.
25