Changing Wheels - Fitting - Volvo XC 60 Owner's Manual

09 Wheels and tyres
||
09
7.
Check that the jack sits in the anchorage
as illustrated and that the foot is posi-
tioned vertically under the anchorage.
IMPORTANT
The jacking point is the rearmost of the
two rear recesses.
8. Lift the car so that the wheel is free.
Remove the wheel bolts and lift off the
wheel.
Related information
•
Changing wheels - fitting (p. 314)
•
Jack* (p. 309)
•
Warning triangle (p. 316)
•
Wheel bolts (p. 308)
*
314
Option/accessory, for more information, see Introduction.

Changing wheels - fitting

It is important that the procedure for fitting
the wheel is carried out correctly.
Fitting
1. Clean the contact surfaces between
wheel and hub.
2. Put on the wheel. Tighten the wheel bolts
thoroughly.
3. Lower the car so that the wheels cannot
rotate.
4. Tighten the wheel bolts crosswise. It is
important that the wheel bolts are tight-
ened properly. Tighten to 140 Nm. Check
the torque with a torque wrench.
5. Refit any full wheel covers.
NOTE
•
After a tyre has been inflated, always
refit the dust cap in order to avoid
damage to the valve from gravel, dirt,
etc.
•
Only use plastic dust caps. Metal dust
caps can rust and become difficult to
unscrew.
NOTE
The wheel cover outlet for the valve must
be positioned over the valve on the wheel
rim during fitting.
WARNING
Never crawl under the car when it is raised
on the jack.
Passengers must leave the car when it is
raised on the jack.
Park the car such that passengers have
the car, or ideally a crash barrier, between
themselves and the roadway.