Volvo XC 60 Owner's Manual page 315

WARNING
Check that the jack is not damaged, that
the threads are thoroughly lubricated and
that it is free from dirt.
NOTE
Volvo recommends only using the jack*
that belongs to the car model in question,
which is indicated on the jack's label.
The label also indicates the jack's maxi-
mum lift capacity at a specified minimum
lifting height.
2. Take out the jack*, wheel wrench* and
removal tool for wheel covers* located
under the cargo floor in the cargo area. If
another jack is selected, see Raising the
car (p. 325).
3. Place chocks in front of and behind the
wheels which will remain on the ground to
prevent them from rolling. Use heavy
wooden blocks or large stones for exam-
ple.
4. Screw together the towing eye with the
wheel wrench* until the stop position in
accordance with the following figure.
IMPORTANT
The towing eye must be screwed into all
threads in the wheel bolt wrench.
5. Loosen the wheel bolts ½-1 turn anti-
clockwise with the wheel wrench.
09 Wheels and tyres
WARNING
Never position anything between the
ground and the jack, nor between the jack
and the car's jacking point.
6. There are two jacking points on each side
of the car. There is a recess in the plastic
cover at each point. Crank the foot of the
jack down so it is pressed squarely on the
ground.
IMPORTANT
The ground must be firm, smooth and
level.
*
Option/accessory, for more information, see Introduction.
09
}}
313