Yamaha TDM900 Owner's Manual page 56

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Oil filter element
2. O-ring (× 2)
5. Remove and replace the oil filter
element and O-rings.
6. Install the oil filter element cover
by installing the bolts, then tighten-
6
ing them to the specified torque.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf)
NOTE:
_
Make sure that the O-rings are properly
seated.
_
7. Install the engine oil drain bolts,
and then tighten them to the spec-
ified torques.
Tightening torques:
Engine oil drain bolt A:
35 Nm (3.5 m·kgf·)
Engine oil drain bolt B:
30 Nm (3.0 m·kgf)
8. Add the specified amount of the
recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter element
replacement:
3.8 L
With oil filter element
replacement:
3.9 L
Total amount (dry engine):
4.7 L
6-11
CAUTION:
_
G In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives with
the oil or use oils of a higher
grade than "CD". In addition, do
not use oils labeled "ENERGY
CONSERVING II" or higher.
G
Make sure that no foreign mate-
rial enters the crankcase.
_
9. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
10. Turn the engine off, and then
check the oil level and correct it if
necessary.
EC000072