Rear Wheel Removal - Yamaha DT125R Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
1. Gap
4
6. Tighten the axle holder nuts to
the specified tightening torque.
5
Tighten the upper nuts first and
then lower ones. When tightened
6
in this sequence, there should be
a gap formed at the bottom of
7
the axle holder.
Tightening torque:
8
Axle holder nut:
10 Nm (1.0 m
9
7. After tightening the holder nuts,
push down on the handlebars
several times and check if the
fork rebounds smoothly.
1
1. Swingarm end bolt ( 2)

Rear wheel removal

w
8 8 It is advisable to have a
8 8 Securely support the motorcy-
0 kg)
1. Loosen the rear axle nut.
2. Elevate the rear wheel by placing
3. Remove the swingarm end bolts.
1
1
Yamaha dealer service the
wheel.
cle so there is no danger of it
falling over.
a suitable stand under
engine.
6-38
2
1. Axle nut
2. Chain adjusting plate
EAU03105
4. Remove the axle nut.
5. Push the wheel forward and
EW000122
remove the drive chain.
6. Pull out the rear axle and remove
the wheel assembly by pulling
backward.
NOTE:
8 Do not depress the brake pedal
when the disc and caliper are
separated.
8 You do not have to disassemble
the chain in order to remove or
the
install the rear wheel.
1