Front Wheel Installation - Yamaha DT125R Owner's Manual

1
3
1. Speedometer cable
2. Axle holder nut ( 4)
3. Wheel axle
3. Elevate the front wheel by plac-
ing a suitable stand under the
engine.
4. Loosen the wheel axle holder
nuts.
5. Remove the wheel axle and the
front wheel. Make sure the
motorcycle is properly supported.
NOTE:
Do not depress the brake lever when
the disc and caliper are separated.
PERIODIC MAINTENANCE AND MINOR REPAIR
2

Front wheel installation

1. Install the speedometer gear unit
housing into the wheel hub.
Make sure the speedometer gear
unit housing is installed with the
projections
slots.
2. Lift up the wheel between the
front fork legs and guide the
brake disc between the brake
pads. Make sure there is enough
gap between the brake pads
before inserting the brake disc.
6-37
EAU03104
3. Make sure the slot in the
4. Install the wheel axle and let the
meshed into the
5. Tighten the wheel axle the speci-
speedometer gear unit fits over
the stopper on the front fork
outer tube.
motorcycle down.
fied torque.
Tightening torque:
Wheel axle:
0
58 Nm (5.8 m kg)
1
2
3
4
5
6
7
8
9