Table of Contents
Advertisement
2. Filter (A) has 2 parts. To disassemble the
filter, pull them apart.
3. Fully clean the parts under running water.
4. Put the 2 parts of the filter (A) together
and push. Make sure that they assemble
correctly in each other.
5. Remove the filter (B).
6. Fully clean the filter (B) under running wa-
ter.
7. Put the filter (B) to its initial position. Make
sure that it assembles correctly under the
two guides (C).
8. Put the filter (A) into position in filter (B)
and turn it clockwise until it locks.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clogged, remove remaining parts of soil with a cocktail
stick.
To clean the external surfaces
Clean the external surfaces of the appliance and control panel with a damp soft cloth. Only
use neutral detergents. Do not use abrasive products, scouring pads or solvents (e.g. ace-
tone).
WHAT TO DO IF...
The appliance does not start or stops during operation.
First try to find a solution to the problem (refer to the chart). If not, contact the service
centre.
Malfunction
The appliance does not
fill with water.
Fault code
• An audible signal
operates.
• The display shows
.
Possible cause
The water tap is
blocked or is furred
with limescale.
17
What to do if...
Possible solution
Clean the water tap.
C
Advertisement
Table of Contents
