Table of Contents
Advertisement
10
Setting the water softener
°dH
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) No use of salt is necessary.
You must adjust the water softener manually and electronically.
Manual adjustment
Turn the water hardness dial to the position 1 or 2
(refer to the chart).
Electronic adjustment
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the programme indicator lights above
function buttons A, B and C start to flash.
4. Release function buttons B and C.
5. Press function button A.
– The programme indicator lights above function buttons B and C go off.
– The programme indicator light above function button A continues to flash.
– The display shows the current adjustment.
Example: the display shows
6. Press the function button A again and again until the display shows the necessary
adjustment.
7. Press the on/off button to keep the operation.
If the water softener is set electronically to the level 1, the salt indicator light stays off.
Water hardness
°TH
mmol/l
65 - 75
6,5 - 7,5
51 - 64
5,1 - 6,4
40 - 50
4,0 - 5,0
33 - 39
3,3 - 3,9
26 - 32
2,6 - 3,2
19 - 25
1,9 - 2,5
7 - 18
0,7 - 1,8
< 7
< 0,7
Clarke
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
= level 5.
Water hardness adjustment
manually
electronically
1)
2
1)
2
1)
2
1)
2
1
1
1
2)
1
8
7
6
1)
5
4
3
2
2)
1
Advertisement
Table of Contents
