Table of Contents
Advertisement
54
What to do if ...
What to do if ...
Problem
The oven does not heat up The oven is not switched on
The oven lighting is not
operating
The pyrolysis function is
not working ("C1" is shown
in the time display)
The oven does not heat up.
Time
is lit
F11 appears in the clock
display
F2 appears in the clock dis
play
An error code not listed
above appears in the time
display
If you are unable to remedy the problem by following the above sugges
tions, please contact your dealer or the Customer Care Department.
Possible cause
The clock is not set
The required settings have not
been set
The oven's safety cut out has
been tripped
The fuse in the house's electri
cal wiring (fuse box) has been
tripped
The oven bulb is faulty
Side rails/oven shelf runners
have not been removed
Demo mode is on
The meat probe has short
circuited or the plug of the
meat probe is not firmly in po
sition in the socket
Door not properly closed or
door lock defective
Fault in the electronics
Remedy
Switch the oven on
Set the current time on the clock
Check the settings
See "Safety fuse"
Check fuse. If the fuses trip repeat
edly, please call an authorised elec
trician
Change the oven bulb
Remove side rails/oven shelf
runners
Keep Selection
button pressed
for 2 seconds, then within 2 sec
onds press and hold buttons Selec
tion
and
for 2 seconds
Insert the plug of the meat probe
as far as it will go into the socket
on the side wall of the oven
Close door properly;
Turn the appliance off and on
again via the house fuse or the
safety switch in the fuse box;
If displayed again, please contact
the Customer Care Department
Switch off the appliance via the
house fuse or the safety switch in
the fuse box and switch it on again
If displayed again, please contact
your local Service Force Centre
Advertisement
Table of Contents
