Electrolux ENA34399W User Manual page 16

16 electrolux
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
Rear spacers
In the bag with the documentation,
there are two spacers which must be
fitted as shown in the figure.
Slacken the screws and insert the spacer
under the screw head, then tighten again
the screws.
3
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.
Removing the shelf holders
Your appliance is equipped with shelf re-
tainers that make it possible to secure the
shelves during transportation.
To remove them proceed as follows:
1. Move the shelf holders in the direction of
the arrow (A).
2. Raise the shelf from the rear and push it
3. Remove the retainers (C).
2
1
Installation of the carbon air filter
The carbon air filter is an active carbon filter
which absorbs bad odours and permits to
maintain the best flavour and aroma for all
foodstuffs without risk of odour cross con-
tamination.
On delivery the carbon filter is in a plastic
bag to maintain it's duration and character-
istics. The filter should be placed behind the
flap before the appliance is turned on.
1. Open the flap cover.
2. Remove the filter from the plastic bag.
3. Insert the filter in the slot found in the
4. Close the flap cover.
Important! The filter should be handled
carefully so fragments do not loosen from
the surface. The filter should change once
every six months.
forward until it is freed (B).
back of the flap cover.