Radio Shack 49-537 Owner's Manual page 14

49-537.fm Page 14 Thursday, August 19, 1999 9:16 AM
5. Connect the wires to the keypad terminals. If
connecting to a Radio Shack system, refer to
the supplied wiring diagrams. Otherwise, refer
to "Connections." To make a connection:
a. Loosen the keypad's screw terminal.
1
b. Strip / inch of insulation from the wire end.
2
c. Wrap the bare wire around the screw termi-
nal. Be sure no stray wire strands touch any
other terminal.
d. Tighten the screw.
6. Set
LATCH IN/OUT
your system.
• When set to
remote terminals when you enter the code,
and keeps them shorted until you enter the
code again. Use this setting if the original
arm/disarm switch is a two-position switch
(one position for armed, the other position
for disarmed) or a normally-closed switch.
14
to the correct position for
, the keypad shorts the
IN