Ramsey Electronics FM100BWT User Manual page 8

ANTENNA ALTERNATIVES:
If your situation involves a single large building or multi-level home where
reception from the FM100B antenna may tend to be uneven because of walls
and other VHF path obstacles, you might set up the FM100B's output in a
"carrier-current" configuration. If you know how, then do so safely. If not, you
can show your FM100B and this book to a licensed radio engineer and
negotiate with that person for a safe installation which will feed your signal
through interior wiring of your home or building. Do not attempt such an
installation unless you know exactly what to do (and what not to do). Because
such an installation is beyond the original purpose of this kit and the safety
standards intended for all Ramsey kits, we cannot provide further details for
such an installation. Just wetting your whistle a bit!
USING YOUR FM100B
•
Setting the frequency:
[1] Press both frequency buttons (FREQ UP and FREQ DN ) at the same
time and hold them in for three seconds to enter the frequency set mode.
The FM100B will confirm your mode selection with 3 short beeps and the
far right decimal point will begin to flash. Note that the far left decimal
point will also flash if the unit is in stereo mode.
[2] Press and hold either FREQ button; the frequency should scroll
accordingly through the valid values.
[3] When you have selected your new operating frequency, press both
frequency buttons again and hold until you hear the triple beep
confirmation. This means the settings have been saved in Flash.
•
Toggling Stereo Mode (Stereo / Mono operation):
[1] Press both frequency buttons (FREQ UP and FREQ DN ) at the same
time and hold them in for three seconds to enter the frequency set mode.
The FM100B will confirm your mode selection with 3 short beeps and the
far right decimal point will begin to flash.
[2] Press the auto AGC button to toggle the stereo mode on and off. Note that
the far left decimal point will flash only if the unit is in stereo mode.
[3] When the mode is selected, press both frequency buttons again and hold
until you hear the triple beep confirmation. This means the settings have
been saved in Flash.
FM100B • 8