Radio Shack DX 275 User Manual page 9

direct access, preset, or scan tuning methods.
Manual Tuning
To manually tune to a frequency, repeatedly press MANUAL/AUTO <DOWN or UP>
until the display shows the frequency desired.
Search Tuning
To let the receiver find a station, press and hold <DOWN or UP> for more
than 2 seconds.
release the button, the receiver automatically tunes to the next strong
station.
Direct Access Tuning
To tune directly to a station's frequency, press ENTER.
about 10 seconds.
select the desired station's frequency.
NOTES: Your receiver automatically rounds the entered frequency to the
nearest valid frequency.
frequency of 1453 in AM, your receiver accepts it as 1450.
If you make a mistake in entering a frequency, ERROR flashes on
the display.
Preset Tuning
To tune directly to a station that is entered into memory, simply press
the desired preset number (0-9).
NOTE: You must first store the desired stations into memory.
"Storing Station Frequencies.")
Scan Tuning
To scan the preset memory locations, press SCAN.
each station for about 5 seconds.
press a preset station memory button.
NOTE: If no frequency is stored in a memory channel or no signal is
received at a memory channel, the receiver stops at the memory
channel for 1 second and then moves to the next memory channel.
STORING STATION FREQUENCIES
For easy selection, you can store up to 30 of your favorite stations'
frequencies in memory (10 frequencies in each band; FM, AM, and SW).
you store a station's frequency using a memory button, you can press this
button to select the stored station.
The tuner quickly scans all frequencies.
While it is flashing, press the number buttons to
Enter the frequency again.
Then press ENTER again.
For example, if you try to enter a
To end scanning, press SCAN again, or
When you
ENTRY flashes for
(See
The receiver stops at
Once