Shark Z1900 Series Owner's Manual page 9

Using Your Shark
IMPORTANT: Do not use the mop without
attaching a microfibre cleaning pocket and
adding water to the tank first. When you are
using the mop for the first time, it might take
longer than the normal 30 seconds to start
steaming. Just pump the handle a few times in a
downward motion to prime the pump.
NOTE: Make sure the floors are swept or
vacuumed before using the Shark
Pocket Mop.
™
1 Pull and twist the quick release cord holder to
unwrap the power cord completely. (Fig. 7)
Plug into an electrical outlet. It takes
approximately 30 seconds for the mop to heat up
and the steam to be ready.
Steam Pocket
®
fig. 7
Steam
®
Mop
™
2
Pump the handle a few times in a downward
motion. This pumping action will release steam
as you mop and allows you to customise the
amount of steam you want. Begin mopping with
a forward and backward motion. The natural
motion of mopping will produce steam. (Fig. 8)
NOTE: The steam mop is on when it is plugged
in. Unplug when you want to turn it off.
Pump for
steam
fig. 8
5