Coolant Level Check; Replacement Of Cooling Fluid - Husqvarna SMR Owner's Manual

COOLANT LEVEL CHECK

Check level (1) in right-hand radiator when engine is cold
(place the motorcycle so that it is perpendicular to the ground).
The coolant should be approximately 10 mm above cells and
besides, on TE-TXC and SMR models, it doesn't exceed the mid-
dle of the expansion tank (2) located in front of the rear shock
absorber.
The radiator cap is provided of two unlocking positions, the
first being for the previous pressure discharge in the cooling
system.
1
32
WARNING
Avoid removing radiator cap when engine is
hot, as coolant may spout out and cause
scalding.
WARNING
TE-SMR: Because the cooling fan (A)
can be activated even when the start switch
is in OFF position, always keep at a safe
distance from the fan vanes.
NOTE
Difficulties may arise in eliminating coolant
from varnished surfaces. If this occurs,
wash off with water.

REPLACEMENT OF COOLING FLUID

Place a vessel on the R.H. side of the cylinder, under the
coolant drain screw (1).
FIRST remove the screw (1) then SLOWLY open the R.H. radia-
tor cap; slope the motorcycle on the right side to drain the
coolant easily in the vessel. Reassemble the screw (1).
Pour the necessary quantity of coolant in the radiator then
warm up the engine in order to eliminate any possible air bub-
ble.
1