Remote Control Operation; Locking The Doors; Unlocking The Doors - Ford Remote Start System Owner's Manual

Remote Control Operation

QUICKSTART
Press to Lock All Doors
Press and Hold to
turn on Headlights**
Press for Car Finder
Press and Hold for
Panic Alarm

Locking the Doors

Using the PowerCode Remote Control Transmitter:
Press* the button on the PowerCode remote control transmitter. The system will
lock the doors and flash the parking lights. If the
within 5 seconds, the system will chirp the horn to confirm that the system has locked
the doors.
Note: Your Power Code system provides the added security feature of starter
interrupt whenever the doors are locked by the OE or Power Code key fob.
Unlocking / locking the doors using the key will not disable / enable the
starter interrupt security feature. If the doors are locked by either the
OE or Power Code key fob you must use either the OE or Power Code key fob to
disable the starter interrupt feature otherwise the vehicle will not start
using the ignition key.
Using the factory supplied Keyless Entry Remote control:
Your PowerCode system while enhancing the convience features offered by your
vehicle does not alter the functions of the factory supplied RKE system (if equipped).
Additionally, Your PowerCode system will also control the extended functions offered
by the factory supplied RKE system (i.e. Memory seat control and/or Power side
sliding doors).
entry into your vehicle.
When the doors are unlocked using the PowerCode remote control transmitter or the
factory supplied RKE keyfob, the system disarms the starter interrupt feature.
* "Press" refers to pushing a transmitter button for approximately one second.
** Optional installation feature, see your dealer for details.
Press to Unlock Drivers
Door (or all doors
depending on installation
options**)
Press Again to Unlock
All Doors*
Press and Hold To
Open Trunk or Hatch*
Press then
to activate Remote Start
Press again to turn
on Rear Defroster*
after remote started
button is pressed a second time
3