Convenience And Safety Features - Ford Remote Start System Owner's Manual

Remote Control Operation (Con't)
Unlocking the Doors
Press* the button on the PowerCode remote control transmitter. The system will
unlock the drivers doors (or all doors depending upon your installed options**) and
flash the parking lights. If the
the system will unlock all doors and chirp the horn confirming that the system has
unlocked the doors. Additionally, the PowerCode system turns on the interior dome
light for one minute, or until the ignition key is turned on to provide an illuminated

Convenience and Safety Features

Activating Headlight control:
Headlight control is an optional feature of your PowerCode security system. To
activate headlight control, press and hold*** the
remote control transmitter. The system will turn the headlights on for 20 seconds or
until the button is pressed again.
Remote Control Power Trunk/Hatch release:
Press and hold*** the button on your PowerCode remote control transmitter. The
system will activate the power trunk or hatch release (if equipped) and unlock the
drivers door (or all doors depending upon installation options).
Note: Make sure to relock the doors if you will be leaving your vehicle unattended
again after opening your trunk or rear hatch.
Remote Control Progressive Find function
The remote control vehicle find function can help locate your vehicle in a crowded
parking lot. Pressing the
chirp the horn 5 times. Subsequent presses of the
press will activate the find function again - sounding the horn slightly louder on the
second and third activations and then at a constant sound level (equal to the third
activation).
Remote Control Panic Mode
The remote control panic function helps draw attention to your vehicle and yourself in
a threatening situation. Press and hold*** the
control transmitter to activate the panic function. Pressing the
PowerCode transmitter prior to the end of the 30 second cycle will end the panic
mode.
* "Press" refers to pushing a transmitter button for approximately one second.
** See your dealer details on available installation features.
*** "Press and Hold" refers to pushing a transmitter button for more than one
second.
4
button is pressed a second time within 5 seconds,
button on your PowerCode
button on your PowerCode remote control transmitter will
button within 5 seconds of first
button on your PowerCode remote
button on the