Mounting The Control Module - Ford SK5W7J-19A361-AA Installation And Technical Reference Manual

MOUNTING THE CONTROL MODULE

1
Plug the connectors for the Securilock interface and
antenna (if not already done) into the control module as
shown.
2
Plug the Status LED into the main wiring harness.
To Status LED
3
A. Using the supplied long tie wraps (X), mount the
control module to underdash wiring harnesses and/
or dash mounting brackets. Module mounting
locations are provided on the last page of the
vehicle specific wiring sections. DO NOT mount the
control module in the knee bolster area. To ensure
best performance of the built-in shock sensor,
securely tie wrap the control module at three points
to the vehicle.
B. Route the different sections of the wiring harness to
the appropriate underdash areas of the vehicle.
Neatness in this area is very important in ensuring a
quality finished installation. Wherever possible, route
the PowerCode system wires along with existing
vehicle wiring harnesses and tie wrap the
PowerCode wiring harnesses to existing vehicle
wiring harnesses.
Make sure to route the PowerCode system wiring so
that it is free and clear of all moving underdash
!
components (i.e. accelerator pedal, adjustable brake
pedal assembly and/or parking brake mechanism).
2W7Z-16A901-AA
20/42
Main wire
harness
SK5W7J-19A361-AA
Trim and tape off
To Securilock
WHITE module
RF Antenna
© Copyright Ford 2005
Rev Date- 8/29/05