Care And Cleaning; Removing Oven Door; Replacing Oven Light - Amana ARDS802 Series Owner's Manual

Care and Cleaning

Removing Oven Door

CAUTION
To avoid personal injury or property damage, handle
oven door with care.
• Door is heavy and can be damaged if dropped.
• Avoid placing hands in hinge area when door is
removed. Hinge can snap closed and pinch hands.
• Do not scratch or chip glass, or twist door.
Glass may break suddenly.
• Replace door glass if damaged.
• Do not lift door by handle.
1. Open door fully.
2. Remove screws.
• Oven doors are attached with a screw on each side
of lower oven door.
3. See Figure 40. Close door to first stop, grasp door
firmly on each side, and lift upward until door is off
hinges.
• Do not lift door by handle. Glass or handle can
break.
• Only push hinges closed once oven door is
removed if necessary. Use both hands when
closing hinge. Hinge snaps closed.
Figure 40

Replacing Oven Light

To avoid risk of burns or electrical shock, disconnect
electrical supply to oven before changing light bulb.
• Before replacing light bulb make sure bulb is cool.
• Wear protective gloves.
• Do not operate oven without bulb and cover in place.
1. Disconnect electrical supply.
2. Remove oven door if desired.
3. See Figure 41. Unscrew light bulb cover
(counterclockwise) located in rear of oven cavity.
Then turn light bulb counterclockwise to remove.
4. Replace light bulb with 120-volt, 40-watt appliance
bulb.
• Do not overtighten bulb or it may be difficult to
remove later.
5. Replace light bulb cover and oven door before use.
6. Reconnect power supply.
Figure 41
28
WARNING