Table of Contents
Advertisement
Figure 12
5. While observing proper ESD procedures (see Special Note above) insert the
PCM2906C PCB sub-assembly on the main PCB. (Figure 13) The PCM2906C
PCB sub-assembly is oriented with Pin 1 on the right hand top side of
the PCB sub-assembly. It may be helpful to use a piece of blue painter's
masking tape to temporarily hold the PCB sub-assembly in place for soldering.
Then, turn the main PCB over and apply flux on each of the pins of the PCB sub-
assembly where it protrudes through the solder hole and solder each pin.
Figure 13
19
Advertisement
Table of Contents
