How To Insert The Cartridge - Mattel Intellivision Owner's Manual

INTELLIVISION MASTER COMPONENT OWNER'S MANUAL
4. Set the Antenna Switch Box at GAME.
5. Turn on your television set.
6. Turn your television set to either Channel 3 or 4, depending on where you set the Master
Component switch in Step 2. If Master Component switch is set on CH 3, turn TV set to
Channel 3. If Master Component switch is set on CH 4, turn TV set to Channel 4.

How to Insert the Cartridge

file:///C|/Documents%20and%20Settings/s/Deskt...ntellivision%20Master%20Component%20Owne1.htm (6 of 14) [9/28/2008 12:13:10 PM]
1. Connect the Switch Box cable to the Switch Box by
plugging it into socket marked GAME CORD. Plug other end
of cable into the Master Component socket in the rear of
the Master Component on the right hand side. It makes no
difference which end goes where; cable is symmetrical.
Your Switch Box is equipped with an adhesive backing for
installation on the back of your TV set. Simply peel off thin
paper layer to expose adhesive surface and place firmly on
desired mounting location.
2. Turn the Master Component over, face down, and see
switch labeled "CH 3-CH 4." (On an INTELLIVISION II, this
switch is on the back of the console.) If Channel 3 is a
normal television station channel or cable channel in your
area and Channel 4 is not, then move the switch to
Channel 4. If Channel 4 is a normal television station
channel or cable channel in your area and Channel 3 is not,
move the switch to Channel 3. If both Channels 3 and 4 are
normal television station channels or cable channels in your
area, move the switch to the channel with the weaker
reception. (If you receive Channel 3 better than Channel 4,
move switch to Channel 4 and vice versa.)
3. Plug the power cord of the Master Component into a wall
outlet. (For the INTELLIVISION II, plug the power supply
into a wall outlet and connect the cord from the power
supply to input jack on back of console.)