How To Connect The Antenna Switchbox - Mattel Intellivision Owner's Manual

INTELLIVISION MASTER COMPONENT OWNER'S MANUAL
may be attached to this computer. Operation with non-certified peripherals is likely to
result in interference to radio and TV reception.

How to Connect the Antenna Switchbox

The Antenna Switch Box enables you to use your television set for either regular television
programming or with Intellivision. Once the Antenna Switch Box is installed, a flick of the
switch allows you to make your choice.
CONNECTING THE SWITCH BOX IS EASY. JUST FOLLOW THESE SIMPLE STEPS:
THE ONLY TOOL YOU WILL NEED IS A FLATHEAD SCREWDRIVER.
Disconnect the VHF twin lead antenna wire (if there is one) from your television set and
connect it to the Antenna Switch Box.
Connect the twin lead wire from the Switch Box to the VHF screw terminals of your
television set.
IMPORTANT!
If you disregard any of the following rules you may cause interference to nearby television
sets.
Never attach loose wires to your antenna terminals when you are using the
Master Component.
The Antenna Switch Box comes with its own twin lead wire. Never
substitute a longer twin lead wire from the Switch Box to your television
set.
Do not attach the twin lead wire from the Switch Box to any television
antenna or cable-TV outlet.
WHERE FLAT "TWIN LEAD" TYPE OF ANTENNA WIRE IS USED
file:///C|/Documents%20and%20Settings/s/Deskt...ntellivision%20Master%20Component%20Owne1.htm (3 of 14) [9/28/2008 12:13:10 PM]