Audio Setup; Speaker Setting - Kenwood KDC-MP6533 Instruction Manual

Audio Setup

Setting the Sound system, such as Cross over
Network.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display
2
Front High Pass Filter* "HPF"
Rear High Pass Filter* 2 "HPR"
1,2
Low Pass Filter* "LPF"
Subwoofer Phase* 1,2,3 "PHAS"
Volume offset "V-OFF"
Loudness "LOUD"
• Volume offset: Sets each source's volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
• * 1 You can control this item when <Subwoofer
Output> (page 10) is set to "SW ON".
• * 2 Function of the KDC-MP6533.
• * 3 You can control this item when Low Pass Filter is not
set to Through.
5
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Range
Through/80/100/120/150/
180 Hz
Through/80/100/120/150/
180 Hz
60/80/120/Through Hz
Reverse (180°) / Normal (0°)
–8 — ±0
OFF/ON

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Speaker Setting mode
Press the [VOL] knob.
3
Select the Speaker type
Turn the [VOL] knob.
Each time you turn the knob, the setting
alternates between the settings shown in the
table below.
Speaker type Display
OFF "SP OFF"
For 5 & 4 in. speaker "SP 5/4"
For 6 & 6x9 in. speaker "SP 6*9/6"
For the OEM speaker "SP OEM"
4
Exit Speaker Setting mode
Press the [VOL] knob.
9
|
English