Page 1
System FLASH BIOS Low ESR Capacitors RJ45 Jack VIA VT82C686B (SB) RJ45 Jack IPMI ROM FAN4 Connector FAN1 Connector VGA Connector System FAN JP5 VGA IRQ Jumper System FAN JP3 CMOS Clear Jump 370-pin CPU Socket with Voltage & 32 Bit PCI Slot x 2 Frequency Auto-detection ®...
1. JP3 Clear CMOS You can clear CMOS to restore system default setting. To clear the CMOS, follow the procedure below. 1. Turn off the system and unplug the AC power. 2. Remove ATX power cable. Everything you need to boot this 3.
3. Installing Processor 5. Setting CPU Voltage & Frequency Setting CPU Core Voltage This motherboard supports CPU VID function. The CPU core voltage will be automatically Pull up the CPU socket lever and up to CPU socket lever detected and the range is from 1.05V to 1.825V. It is not necessary to set CPU Core Voltage 90-degree angle.
Page 4
6. JP2 IDE RAID / ATA Controller Jumper 8.JP5 VGA IRQ Jumper This jumper allows you to decide the system to support IDE RAID or ATA interface. The This jumper allows you to enable or disable VGA sending IRQ to the system. The default default setting is IDE RAID.
10. JP11 BIOS Restore Function 12. Connecting ATX Power Connector This jumper allows you to enable or disable the BIOS restore function. The default setting The ATX power supply uses 20-pin connector shown below. The connector is equipped is Disable. with a foolproof device.
14. Support 10/100 Mbps LAN Onboard 16. Back Panel On the strength of Intel 82550 PHY on board, which is a highly-integrated Platform LAN The picture shown below indicates the functions of all connectors on the real panel. The Connect device, it provides 10/100M bps Ethernet for office and home use, the Ethernet RJ45 connectors are all different in their shape or color.
18. Power-On and Load BIOS Setup If you encounter any trouble to boot you system, follow the procedures accordingly to resolve the problem. After you finish the setting of jumpers and connect correct cables. Power on and enter the BIOS Setup, press <Del> during POST (Power On Self Test). Choose "Load Default Start Setting"...
Page 8
Dear Customer, Test Report: We recommend to choose board/card/device from the Thanks for choosing AOpen products. To provide the best and fastest service to compatibility test reports for assembling your PC. our customer is our first priority. However, we receive numerous emails and http://www.aopen.com/tech/report/default.htm...