What To Do If - AEG Electrolux E9871-5 User Manual

48

What to do if ...

What to do if ...
Problem
The cooking zones are not
functioning.
The oven is not heating up
The oven lighting is not op-
erating
The pyroluxe is not working
In the display C1-REMOVE
RUNNERS appears
F11 appears in the clock
display
F2 appears in the clock dis-
play
A fault code that is not list-
ed above appears in the
clock display
If you are unable to remedy the problem by following the above suggestions,
please contact your local Service Force Centre.
Warning! Repairs to the appliance are only to be carried out by qualified service engi-
1
neers. Considerable danger to the user may result from improper repairs.
If the appliance has been operated incorrectly, the engineer's visit will be chargeable,
3
even during the warranty period.
Possible cause
Refer to the operating instructions for the built-in cooking surface
The oven has not been switched
on
The clock has not been set
The required settings have not
been set
The oven's automatic cut-out
has been triggered.
The house wiring fuse (in the
fuse box) has tripped
The oven light bulb is faulty
Side rails/oven shelf runners
have not been removed
The meat probe has short
circuited or the plug of the meat
probe is not firmly in position in
the socket
Door not closed properly or door
lock faulty
Electronic fault
Remedy
Switch oven on
Set the current time on the clock
Check the settings
See Automatic cut-out
Check fuse. If the fuses trip sev-
eral times, please call a qualified
electrician
Replace oven light bulb
Remove side rails/oven shelf
runners
Insert the meat probe plug into
the socket on the oven side wall
as far as it will go.
Close door properly;
Switch the appliance off and on
again via the house fuse or the
safety switch in the fuse box;
If it is displayed again, please
contact the Customer Care De-
partment
Switch the appliance off and on
again via the house fuse or the
safety switch in the fuse box.
If it is displayed again, please
contact the Customer Care De-
partment