Network Stack Configuration - Asus H81T User Manual

Change Settings [IO=3F8h; IRQ=4]
This item appears only when you set the Serial Port to [Enabled] and allows you
to select the Serial Port base address. Configuration options: [IO=3F8h; IRQ=4]
[IO=2F8h; IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
2.6.9 APM
ErP Ready [Disabled]
Allows you to switch off some power at S4+S5 or S5 to get the system ready for ErP
requirement. When set to [Enabled], all other PME options will be switched off. Configuration
options: [Disabled] [Enabled]
Restore AC Power Loss [Power Off]
[Power On]
[Power Off]
[Last State]
Power On By PCIE [Disabled]
[Disabled]
[Enabled]
Power On By Ring [Disabled]
[Disabled]
[Enabled]
Power On By RTC [Disabled]
[Disabled]
[Enabled]
2.6.10

Network Stack Configuration

Network Stack [Disabled]
This item allows user to disable or enable the UEFI network stack. Configuration options:
[Disabled] [Enabled]
The following two items appear only when you set the previous item to [Enabled].
Ipv4 / Ipv6 PXE Support [Enabled]
This item allows user to disable or enable the Ipv4 / Ipv6 PXE Boot support. Configuration
options: [Disable Link] [Enabled]
2-30
The system goes into on state after an AC power loss.
The system goes into off state after an AC power loss.
The system goes into either off or on state, whatever the system state was
before the AC power loss.
Disables the PCIE devices to generate a wake-on-LAN feature of the
Intel /Realtek LAN device.
®
Enables the PCIE devices to generate a wake-on-LAN feature of the Intel
Realtek LAN device.
Disables Ring to generate a wake event.
Enables Ring to generate a wake event.
Disables RTC to generate a wake event.
When set to [Enabled], the items RTC Alarm Date (Days) and Hour/
Minute/Second will become user-configurable with set values.
Chapter 2: Getting started
/
®