Elation Event Bar User Instructions page 5

Event Bar
System Menu.
The Event Bar comes with an easy to navigate system
menu. This next section will detail the functions of each command in
the system menu. Please read the next section thoroughly!
To access the main menu press the MENU button. Tap the UP or DOWN
buttons until you reach function you wish to change. When you reach
the function you wish to change press the ENTER button. When a
function is selected use the UP or DOWN buttons to change the func-
tion settings. Once your changes are made press the ENTER button,
and then press and hold the MENU button for at least three seconds
to confirm and lock the change into the system memory. If the MENU
button is not pressed and held within eight seconds the fixture will
automatically confirm and lock the change into the system memory. To
exit without making any changes press the MENU button.
DMX Address - Set the DMX Address
1. First set the unit to your desired DMX Channel mode.
2. To set your address, tap either the MENU, UP, or DOWN but-
tons until "DMX Address" is displayed, press ENTER. "1" will
now be displayed and flashing.
3. Press the UP or DOWN buttons to find your desired address.
When you have found your desired DMX address press ENTER,
and connect your DMX Controller. Then press and hold MENU
for 3 seconds to activate DMX control.
Channel Mode - This will let you switch between the 3 DMX
Channel Modes.
1. Press the MENU button until "Channel Mode" is displayed,
press ENTER. Either 12 Channel Mode, 14 Channel Mode, or
25 Channel Mode will be displayed.
2. Press the UP or DOWN buttons to choose your desired DMX
mode and press ENTER to confim and exit.
Slave Mode - This will let you set the unit as a master or
slave in a master/slave configuration.
1. Press the MENU button until "Slave Mode" is displayed,
©Elation Pr fessionals® - www.elationlighting.com - Event Bar Instruction Manual Page 9
o
System Menu & Operation Event Bar
press ENTER. Either Master, Slave 1, or Slave 2 will be dis-
played.
2. Tap the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
NOTe: In a Master/Slave configuration you can set one fixture
to Master and then set the next fixture to Slave 2, the fixtures
will now have contrast movement to each other.
Show Mode - Show modes 0-12 (Factory Installed Shows).
This will let you choose one of the 12 preprogrammed
shows. You can run show mode with sound active mode on
or off.
1. Press the MENU button until "Show Mode" is displayed, press
ENTER.
2. "Show X" will now be displayed, "X" representing a number
between 0-12. Shows 1-12 are factory installed shows, while
"Show 0" is random mode. Press the UP or DOWN buttons to
find your desired show and press the ENTER, then press and
hold the MENU button for at least 3 seconds to activate your
selected show.
Sound State - Sound Active mode.
1. Tap the MENU button until "Sound State" is displayed, press
ENTER.
2. The display will show either ON or OFF. Press the UP or
DOWN buttons to select ON to activate sound active mode, or
OFF to deactivate sound active mode.
3. Press ENTER to confirm, then press and hold the MENU
button for at least 3 seconds to activate sound active mode.
Blackout - Blackout or Stand by mode.
1. Press the MENU button until "Blackout" is displayed, press
ENTER. Either Yes or No will be displayed.
©Elation Pr fessionals® - www.elationlighting.com - Event Bar Instruction Manual Page 10
o
System Menu & Operation