Rear Panel
The rear panel provides the following ports:
•
One USB port for connection to a PC
•
One RJ-45 port for connection to a 10BASE-T/100BASE-TX
Ethernet Local Area Network (LAN). This port operates at
10/100 Mbps, half/full duplex, and is wired as MDI/MDI-X .
•
One RJ-11 port for connection to your ADSL service provider's
incoming line, using a voice/data splitter for full-rate ADSL (G.dmt)
or a direct connection for splitterless ADSL (G.lite).
Figure 2-1. Rear Panel
System Requirements
You must have access to an ADSL network that meets the following
minimum requirements:
•
ADSL service from your local telephone company or Internet Service
Provider (ISP), or access to an ADSL Digital Subscriber Line Access
Module (DSLAM) at your local site.
•
PC configured with a fixed IP address or using dynamic IP address
assignment via DHCP, as well as a Gateway server address and DNS
server address from your service provider or network administrator.
•
You need to get Virtual Channel Identifiers (VCI) and Virtual Path
Identifiers (VPI) from your service provider or network administrator
to set up a Permanent Virtual Connection (PVC) for your ATM data
flow.
S
R
YSTEM
EQUIREMENTS
2-3