Stacking; Figure 3-4. Stacking The Hubs - SMC Networks TigerStack II 10/100 User Manual

Stacking

A stack may have as many as six hubs.
Note: Be sure to have one stacking cable for each device you
plan to stack. A stacking cable is included with each hub.
Caution: DO-NOT stack SMC's 10 Mbps TigerStack hubs with
To stack the devices:
1. Locate the SCSI connectors labeled "IN" and "OUT" on the rear
of each device (see Figure 3-4).
2. Attach one end of the stacking cable to the SCSI connector
labeled "OUT" on the top device, and the other end to the
connector labeled "IN" on the next lower device.
3. Repeat this step until all the devices have been connected.
4. Turn to the next section, "Connecting to a Power Source."

Figure 3-4. Stacking the Hubs

SMC's TigerStack II 10/100 hubs. If you attempt to do
so, the hubs will be damaged.
I S
NSTALLING THE
3-7
TACK