Table of Contents
Advertisement
• Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the
countdown begins, and the delay time value
decreases by one unit every hour.
You can delay the start of the selected programme
by up to 23 hours in one hour intervals.
• An incorrect option selection has been made: this
is indicated by the message Err when a function
incompatible with the current programme is selected.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 90).
9 START/PAUSE button
(Start/Pause - Départ/Pause)
This button has two functions:
• Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
If you have selected a delay time by means of
button 10, the countdown will begin and will be
shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
9 SKIP/RESET button
At the end of a programme, you must press this
button, the
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the washing machine on, the blinking zero will
reappear.
You can also press the RESET button to exclude
one or several phases of the programme which is
running, as indicated below.
- set the washing machine to PAUSE by pressing the
- press the RESET button once or several times, until
Example:
This button allows you also to select special
programmes, such as RINSES, SPIN and DRAIN.
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress RESET once or repeatidly to cancel the
- select the type of fabric by means of the relevant
- select the special programme:
79
above the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle and it becomes
possible to open the door, provided
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
START/PAUSE button (the relevant light will flash);
the required phase(s) is(are) cancelled (the light next
to the symbol of the phase(s) will go out).
previously performed programme (three blinking
dashes will appear on the display);
button;
• RINSES
In this case, the spin (at
the speed provided for
the selected type of
fabric) will be
performed.
Hide quick links:
Advertisement
Table of Contents
