Skip/Reset Button - Electrolux EW1220N Instruction Book

tests, and this cycle has not been erased after its
completion.
• Delay start, a time value indicated in hours and
selected by means of the relevant button
(GECIKTIRME).
The delay time is displayed for 5 seconds, then the
duration of the selected programme reappears.
After you have pressed the START/PAUSE button,
the countdown begins, and the delay time value
decreases by one unit every hour.
You can delay the start of the selected programme
by up to 24 hours in one hour intervals.
• An incorrect option selection has been made:
this is indicated by the message Err when a function
incompatible with the current programme is selected.
The incorrect selection is also indicated by an
audible warning signal.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 23).
9 START/PAUSE button
(Baçlat/Beklet)
This button has three functions:
• Start: after you have selected the desired
programme and options, press this button to start the
washing machine. The light above the button will
stop flashing and remain lit.
If you have selected a delay time by means of
button L, the countdown will begin and will be shown
on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, the DOOR LOCKED
light goes out, and it becomes possible to open the
door, provided
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
Important!
You must set the washing machine to PAUSE before
you make any change in the programme in progress.
• Draining of water and spinning after the
execution of programmes with the RINSE HOLD
(SUDA BEKETME) option.

10 SKIP/RESET button

(ILERLETME/IPTAL)
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the washing machine on, the blinking zero will
reappear and the audible warning signals relevant to
the end of the previous cycle will be given.
You can also press the SKIP/RESET button to
exclude one or several phases of the programme
which is running, as indicated below.
- set the washing machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the SKIP/RESET button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the name of the phase(s) will go
out).
12