Dell INSPIRON 530 DCMF Owner's Manual page 137

7 If you are not reinstalling the Media Card Reader, replace the drive panel
insert, as needed.
8 Replace the bezel (see "Replacing the Bezel" on page 122).
9 Replace the computer cover (see "Replacing the Computer Cover" on
page 160).
10 Connect your computer and devices to electrical outlets, and then turn
them on.
Installing a Media Card Reader
1 Follow the procedures in "Before You Begin" on page 99.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 101).
3 Remove the bezel (see "Removing the Bezel" on page 121).
4 If this is a new card reader installation:
• Remove the drive panel insert (see "Removing the FlexBay Break-Away
Metal Plate" on page 134).
• Remove the Media Card Reader from its packaging.
5 Gently slide the Media Card Reader into place in the FlexBay slot.
6 Align the screw holes in the Media Card Reader with the screw holes in the
FlexBay.
7 Tighten the two screws to secure the Media Card Reader.
NOTE:
cable is connected.
8 Connect the FlexBay USB cable to the back of the Media Card Reader and
to the internal USB connector on the system board (see "System Board
Components" on page 104).
Ensure that the Media Card Reader is installed before the FlexBay
Removing and Installing Parts
137