Dell DIMENSION E510 DCSM Owner's Manual page 79

9 If you replaced a card that was already installed in the computer and you removed the retention
mechanism, you may reinstall the retention mechanism.
10 Before replacing the card retention mechanism, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
11 Snap the card retention mechanism into place, securing the x16 PCI card.
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the cards can prevent the
computer cover from closing properly or cause damage to the equipment.
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug it into the computer.
12 Replace the computer cover, reconnect the computer and devices to electrical outlets, and then turn
them on.
13 If you installed a sound card:
Enter system setup (see "System Setup" on page 109), select Audio Controller, and then change
a
the setting to Off.
Connect external audio devices to the sound card's connectors. Do not connect external audio
b
devices to the microphone, speaker/headphone, or line-in connectors on the back panel.
14 If you installed an add-in network adapter and want to disable the integrated network adapter:
Enter system setup (see "System Setup" on page 109), select Integrated NIC, and then change the
a
setting to Off.
Connect the network cable to the add-in network adapter's connectors. Do not connect the
b
network cable to the integrated connector on the back panel.
15 Install any drivers required for the card as described in the card documentation.
release tabs (2)
Removing and Installing Parts
card retention
door
card retention
mechanism
79