JVC GY-DV5100 Instructions Manual page 37

Using an Anton-Bauer Battery Pack
To use an Anton-Bauer battery pack (DIONIC 90, Propack 13/14, Trimpack 13/14, Magnum 13/14, Compack 13/14 Series), it is
necessary to detach the battery case from the GY-DV5100 and replace it with the Anton-Bauer battery holder. Use the following
battery holder.
• Battery holder: Anton-Bauer QR JVC DIGI
Detaching the Battery Case From the GY-DV5100 and Attaching The Anton-
Bauer Battery
2.
1.
Black screw A
1.
Remove the two black screws A on the battery case.
2.
Remove the lower half of the battery case cover in the
downward direction.
3.
Mount screw B
3.
Mount screw B
3.
To remove the battery case, remove the four screws B fixing
the battery case and the connector connecting the battery
case to this unit.
Attaching and Detaching an Anton-Bauer Battery Pack
Cassette cover side panel
Guide holes
(×3)
Release
lever
Side panel
with display
3.
Connector
Guide pins
Battery pack
LCD BRIGHT
AUDIO
LEVEL
CH-2
CH-1
AUDIO INPUT
AUDIO SELECT
CH-1
Attaching the Anton-Bauer Battery Holder
5.
5.
Anton-Bauer
Battery holder
4.
Connect the 2 connectors protruding from the battery holder
to the connectors on the camera.
CAUTION:
● Following connection of the connectors, insert them into
the connector compartment.
Take care not to pinch the wires. This could result in
damage.
● The Anton-Bauer Battery Holder has pin connectors. Be
careful not to touch these pin terminals when attaching
or removing the battery and holder. Doing so may cause
injury.
5.
Secure the battery holder to the GY-DV5100 with the four
mount screws provided with the battery holder.
Attaching the Battery Pack
1.
Align the 3 guide pins of the battery pack with
the guide holes on the battery holder, and push
straight to insert the battery pack.
The battery cannot be attached properly if the
Release lever
guide pins are not inserted straight.
2.
Slide the battery pack toward the side panel
where the cassette cover is located until it clicks.
Now the battery pack has been attached.
OPEN
DISPLAY
Detaching the Battery Pack
PULL
OPEN
FRONT
REAR
CH-2
CH-2
AUTO
MANUAL
■ While pushing the release lever, slide the battery
pack toward the side panel where the LCD display
Battery
is located, then pull the battery pack outward to
remove.
4. POWER SUPPLY
Be careful of pins.
4.
Wire layout
Connector
Compartment
E-37